Compatibility Operate up to 4 compatible systems in typical setting, up to 8 maximum under ideal conditions System Operating Range Indoors: Up to 100 feet (30 m) typical, with a maximum of 200 feet (60 m) under ideal conditions Outdoors: Up to 65 feet (20 m) typical, with a maximum of 165 feet (50 m) under ideal conditions Transmit Mode Frequency Hopping Audio Frequency Response 20 Hz – 20 kHz Note: Dependent on microphone type Dynamic Range 120 dB, A-weighted Latency Group 1: 4.0 ms 2: 7.3 ms 3: 7.3 ms RF Sensitivity -88 dBm, typical Total Harmonic Distortion 0.2%, typical RF Output Power 10 mW E.I.R.P. max Operating Temperature Range -18°C (0°F) to 57°C (135°F) Note: Battery characteristics may limit this range. Storage Temperature Range -29°C (-20°F) to 74°C (165°F) Polarity Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low-impedance output) and the tip of the high impedance 1/4-inch output. Battery Life Up to 16 hours NOTE: All Specifications are subject to change. Performance may vary depending on country regulations and operating environment

Dimensions 40 x 183 x 117 mm (1.6 x 7.2 x 4.6 in.), H x W x D Weight 286 g (10.1 oz.) Housing Molded Plastic Power Requirements 14 to 18 V DC (negative ground), 550 mA Spurious Rejection >35 dB, typical Gain Adjustment Range -20 to 40 dB in 1 dB steps Phantom Power Protection Yes Configuration XLR Output Impedance balanced 6.35 mm (1/4″) output Impedance balanced Impedance XLR Output 100 Ω 6.35 mm (1/4″) output 100 Ω (50 Ω, Unbalanced) Maximum Audio Output Level XLR connector (into 600 Ω load) 0 dBV 6.35 mm (1/4″) connector (into 3 kΩ load) +8.5 dBV Pin Assignments XLR Output 1=ground, 2=hot, 3=cold 6.35 mm (1/4″) connector Tip=audio, Ring/Sleeve=ground Receiver Antenna Input Impedance 50 Ω Antenna Type ½ Wave Sleeve Dipole, non-removable Maximum Input Level −20 dBm www.shure.com ©2013 Shure Incorporated Component Specifications (Continued) GLXD6 Guitar Pedal Wireless Receiver Dimensions 46 x 95 x 133 mm (1.8 x 3.7 x 5.2 in.), H x W x D Weight 504 g (10.1 oz.) without batteries Housing Cast Metal, Black Powdercoat Tuning Accuracy ± 1 cent Tuning Range F♯ 0 to C8 Power Requirements 9 to 15 V DC, 250 mA min., 400 mA max. Compatible with positive tip or negative tip power supplies. Spurious Rejection >35 dB, typical Gain Adjustment Range -20 to 40 dB in 1 dB steps Configuration 6.35 mm (1/4″) output Impedance balanced Impedance 6.35 mm (1/4″) output 100 Ω (50 Ω, Unbalanced) Maximum Audio Output Level 6.35 mm (1/4″) connector (into 3 kΩ load) +8.5 dBV Pin Assignments 6.35 mm (1/4″) connector Tip=audio, Ring/Sleeve=ground Receiver Antenna Input Impedance 50 Ω Antenna Type PIFA antennas